ADP2100-B High Voltage Differential Probe - battery powered
Features
  • Battery (battery powered)
  • Bandwidth: 100MHz
  • Overload alarm indicator
  • Overload alarm buzzer
  • Bandwidth limit: 5MHz / Full
  • Can be used on any oscilloscope with BNC interface
  • Safety level: EN 61010-031: 2002 +A1:2008
  • Double-layer insulated electronic wire, extra layer of protection, better safety
Features
  • Battery (battery powered)
  • Bandwidth: 100MHz
  • Overload alarm indicator
  • Overload alarm buzzer
  • Bandwidth limit: 5MHz / Full
  • Can be used on any oscilloscope with BNC interface
  • Safety level: EN 61010-031: 2002 +A1:2008
  • Double-layer insulated electronic wire, extra layer of protection, better safety

Description

ADP2100-B is a high-performance differential voltage measurement probe with a BNC interface that can be easily connected to any oscilloscope with a corresponding interface. It is powered by a battery and does not require an additional power supply. It is suitable for various electronic tests and unusable applications. The confidential measurement environment of the USB interface allows users to safely measure differential voltages up to ±1400 V.

When your measurement exceeds the linear range of the probe, the ADP2100-B provides visual and audible warning indicators to ensure that you can promptly detect that the measurement is out of range, prevent possible damage or danger, and help protect the safety of equipment and test work.

Attenuation magnification 1:20/200
DC gain accuracy ±2%
Zero offset (Scope gain=1X) ±10 mV
Bandwidth(-3dB) 100MHz
Impedance of both input terminals 10Mohm, 1pF
Single-ended impedance to ground 5Mohm, 2pF
Rise time (small signal, 10-90%, 20-30°C) ≦3.7ns
Input differential voltage 200X: ±1400V
20X: ±140V
Input common mode voltage ±1400V
Input voltage safety level CAT II 1000V
CAT III 600V
Impulse withstand voltage 4000V
Common Mode Rejection (Typical) 60Hz: > 80dB
100kHz: > 60dB
3MHz: > 40dB
10MHz: > 35dB
Power requirements Carbon zinc battery*4, power supply for 2~3 hours/Alkaline battery*4, power supply for 7~9 hours
BNC/USB cable length 90cm
Probe lead length 24cm